Twin Screw Extruder

twin screw extruder host a zone temperature is too low:

1. Temperature control meter fails: whether the OUT1 light in the low temperature section is on.

2. If the stop valve is too large, disassemble the solenoid valve core and blow it with an air pump.

3. The heater power is too small or the heater half is damaged or short-circuited.

twin screw extruder temperature control table failure:

1. The shut-off valve is too small.

2, screw shear is too strong: appropriate weakening.

3. The solid state relay or bidirectional thyristor is damaged: replace the solid state or thyristor.

4. Whether the high temperature section OUT2 light comes on.

cooling system fault:

1. Whether the water pipe or cylinder is blocked.

2. Check whether the solenoid valve is normal. Under normal circumstances, disassemble the solenoid valve core and blow it with an air pump.